This is a problem solving latch for doors with a narrow stile. Fits old fashioned knobs or levers with a square spindle. Clever design fits 8mm spindles on the square and 7mm spindles on the diamond.
Shown above in polished brass. Available in 4 finishes. See popup menu below. See below for an example used with an Emtek lock.
Works with Emtek passage locks using exposed screws on standard rosettes. Requires about a 60 degree rotation to fully retract. The hub will continue to turn to 65 degrees, however at 65 degrees, the latch is over retracted. Standard Emtek passage sets use a 60 degree latch. Emtek locks using concealed screws or with Stretto sideplates require a 28 degree latch. Please note: Emtek locks with the 28 degree upgrade latch will not work with this latch. If you intend to use this latch with an Emtek lock, order the lock with the standard 60 degree latch. Also, you need to replace the die-cast Emtek spindles with a 8mm solid steel spindle. See below.
Mortise size: 5/8" wide x 1-1/4 tall x 2-5/16" deep.
Faceplate size: 2-1/4" x 5/8".
Strike plate: 2-3/4" x 1-1/8".
|8mm Spindle OnlySteel spindle for use with Emtek locks, narrow and extra long backset latches & others. Measures 8mm square x 4-1/2" long. May be shortened with a hacksaw.|
|.Example above shows 1-3/4" backset latch being used with Emtek Milano lever with square rosette in satin nickel. The finish of the latch is satin stainless. The standard Emtek spindles have been replaced with a steel spindle. With this latch the Emtek lock may be used on a thinner than usual door.
Many different passage sets are available at www.emtek.com. We are an Emtek dealer. Call 215-247-0945 to order any Emtek lock.|
This exact configuration may be ordered below. Please choose door handing. Above example is hinged right.