Custom Narrow Backset Latchbolts

Shown is a 1-3/4" backset latch bolt only. Also available in 1-1/2" and 2" backset.

Shown in satin stainless steel finish. Available in any finish.

Shown with an 8mm hub. Available with a variety of hubs to fit different manufacturers trim.

Available with different strength springing for different weights of door hardware.

Suitable for minimum 1-1/8" thick doors.

Latch is fully retracted at 33 degrees.

This will work with passage sets requiring a 28 degree latch such as the Emtek Stretto passage sets. When turned only 28 degrees, latch is not fully retracted, latch will be 1/16" extended from faceplate at 28 degrees.

This latch will not work with any Emtek rosette sets as the spacing between the 2 screw posts on a standard Emtek rosette set is 1-3/8" and this lock case is 1-3/4" tall.

Faceplate measures 3/4" x 3".

Mortise is 1-3/4" tall x 1/2" thick x 2-1/2" deep.

Strike measures 3" tall x 3/4" wide. Center to edge of lip is 7/8".

Call 215-247-0945 for pricing.